1. Turn on the ultrasonic cleaning machine

When the ultrasonic cleaning machine is working normally, ultrasonic waves are emitted from three directions together. Pressing the bottom ultrasonic button will activate the ultrasonic waves on both sides. Turning the power adjustment knob to the right will activate the bottom ultrasonic button. And rotate it to the appropriate power, at which point the LEO display will show the current bottom ultrasonic working power value.

2. Stop the ultrasonic cleaning machine

If you want to stop the cleaning process, you should first turn the power knob to the minimum. Press again to stop the bottom ultrasound. The cleaning time should be determined based on the condition of the cleaned surface.

3. Overflow of ultrasonic cleaning machine

If there is too much floating oil on the liquid level of the cleaning tank The overflow device of the cleaning machine should be opened to remove it, in order to prevent secondary contamination of the cleaned workpiece.

The specific operation is as follows: Open the overflow discharge valve, inject water or cleaning solution into the cleaning tank until the cleaning solution starts to overflow (it is recommended to use a scraper or similar tool to cut and apply floating oil towards the overflow port to promote its rapid outflow), and keep the overflow discharge valve closed to prevent accidental overflow and ground pollution.

4. Post treatment of ultrasonic cleaning machine

Take out the cleaned parts, thoroughly blow off the residual cleaning solution in each hole of the tool with compressed air, and dry the surface (it is recommended to equip a dust gun in conjunction with an air compressor). If possible, it is recommended to equip a water tank near the cleaning machine. In order to rinse the extracted components.

5. Treatment of cleaning agents for ultrasonic cleaning machines

When the cleaning machine washes too many parts, the content of sludge in the cleaning agent will be quite high, coupled with the emulsifying effect of ultrasound. Cleaning agents may weaken their ability to generate cavitation due to being too dirty and sticky, and should not be continued to be used. It is recommended that users equip water storage tanks and cooperate with cleaning machines to deposit dirty cleaning agents for recycling and reducing costs.

6. The auxiliary effect of ultrasonic cleaning machine soaking

Many components, such as cylinder heads, pistons, connecting rods, turbochargers, intake and exhaust manifolds, have carbon deposits on them. Some are lighter and can be easily cleaned, while others are heavier. In this situation, the necessary soaking and softening process for the workpiece will achieve better cleaning results.

Article source: Kaiping ultrasonic cleaning machine http://www.kpzfcsb.com/