1. Pour clean water into the tank of the ultrasonic cleaning machine

2. Put the items that need to be cleaned into the inner groove

3. Open the cleaning machine and set the temperature, frequency, time, etc., but household ultrasonic cleaning machines do not need to be set

4. Wait for the cleaning to finish, take out the item and rinse it with clean water

Open all

Simply place it in the slot to start, wash it and take it out.

1. Do not splash conductive liquid (such as water) into the air inlet at the top of the ultrasonic control cabinet. Otherwise, it will cause serious damage to the wiring system of the cleaning equipment.

2. Pay attention to keeping the machine clean and turn off the power when not in use.

3. Prevent collision or severe vibration of the machine.

4. Stay away from heat sources.

5. The machine should be stored in a damp environment.

The continuous operation time of the machine shall not exceed 4 hours. If the continuous operation time is too long, the ultrasonic adjustment knob should be rotated to "; 0" Allow the cooling fan to continue operating and continue cooling the ultrasonic control cabinet for at least 2 minutes while the Dongguan ultrasonic cleaning machine is not starting.

6. Before shutting down a cleaning machine that has been running for a long time, the power knob should be adjusted to zero first, and the fan should be used for another 3-6 minutes before shutting down to ensure that the heat inside the power supply is dissipated.

7. The cleaning solution should be promptly precipitated, filtered, or replaced to ensure effective cleaning. To ensure the long-term normal operation of Dongguan ultrasonic cleaning machine, in addition to preventing non-standard operation, it is also necessary to regularly maintain and protect the cleaning machine, and do the following tasks: ① Regularly clean the contaminated cleaning solution in the oil storage tank.

② Regularly run the oil pump for at least 10 minutes each time.

③ After using the cleaning machine, cover it with a cover and do a good job of dust and moisture prevention.

Daily protection - after each operation

Flush the hose and filter connected to the cleaning agent to remove any residue of detergent to help prevent corrosion.

Turn off the water supply system connected to the high-pressure cleaning machine.

Pulling the trigger on the servo spray gun rod can release all pressure in the hose.

Remove the rubber hose and high-pressure hose from the high-pressure cleaning machine.

Block the connecting wire of the spark plug to ensure that the engine will not start (applicable to engine models).

Article source: Kaiping ultrasonic cleaning machine http://www.kpzfcsb.com/