1. Cleaning basket: It is recommended to use stainless steel baskets instead of plastic frames to avoid static electricity;

2. Cleaning time: The cleaning time for each process is set at 3-5 minutes. If the surface area of the cleaning material is large or the structure is complex, the cleaning time can be adjusted appropriately according to the situation. If the cleaning material is prone to stacking and adhesion, shake the workpiece when placing and removing the cleaning material from the tank to allow the cleaning agent to fully touch the workpiece and improve the cleaning effect;

3. Liquid addition: The tank solution should not be filled too full to avoid the phenomenon of mixing between two ultrasonic cleaning agents and cleaning the bottom of the basket with mucus when draining;

4. Cross slot application: Each slot of ultrasonic cleaning agent should be an independent operating process to prevent the two slots from using cleaning agents interchangeably or artificially reducing the operating process and time. The maximum possible use of ultrasonic cleaning agent should be increased to reduce waste;

5. Work environment: Ultrasonic cleaning should adhere to air circulation and prevent the introduction of open flames or substances that are prone to open flames at the work site. The temperature of the liquid in the cleaning tank should be controlled below 50 degrees to reduce the evaporation of ultrasonic cleaning agents.

Article source: Jiangmen Ultrasonic Cleaning Machine http://www.kpzfcsb.com/