The ultrasonic cleaning method is very simple. Put the item to be cleaned into the inner tank, pour in an appropriate amount of water, and if necessary, add cleaning agent. Then turn on the machine for cleaning. Some also need to choose the frequency and time, usually adjusted according to the cleaning material~

1. Rough washing

(1) Firstly, place the ultrasonic cleaning machine in place. Before powering on, place the "active/manual" switch in the manual position and close the inlet and outlet solenoid valves. The rough cleaning time is about 5-10 minutes.

(2) After washing for the first time, turn off the ultrasonic switch and open the drainage valve to drain the contaminated water. Then refill the ion water to the overflow position and clean for 3-5 minutes. After the rough cleaning is completed, it is necessary to purify the filter element. If the requirements are strict, a rough cleaning should be carried out. [1]

2. Fine washing

(1) Ultrasonic manual cleaning

1. Take out the filter element that has been roughly cleaned, install the pre prepared fixtures (different fixtures are used for different types of 10 inch and 20 inch), and place the filter elements one by one in the cleaning tank;

2. Open the ultrasonic switch and motor rolling switch; Turn on the external water inlet switch for internal and external backwashing. If there is an external purified air, turn on the air inlet switch (as a filter element to accelerate cleaning and drying). The fine cleaning time is about 1-3 minutes.

(2) Ultrasonic active cleaning

1. Before powering on, place the "active/manual" switch in the active position and the water inlet switch in the closed state. At the first moment, the relay controls the cleaning time. At the second moment, the relay controls the water inlet, air inlet, and circulation time

2. Set the cleaning time and water intake circulation time, remove all the filter elements after rough cleaning, install the pre prepared fixtures (different fixtures are used for different types of 10 inch and 20 inch), and place the filter elements one by one in the cleaning tank;

3. Connect the power supply, turn on the ultrasonic switch and motor rolling switch, adjust the "active/manual" switch to the active position, replace and turn on the inlet solenoid valve according to the set time, backwash the filter element inside and outside, and clean it for 7-8 minutes

Article source: Kaiping ultrasonic cleaning machine http://www.kpzfcsb.com/