The need for welding materials with amplitude for ultrasonic cleaning machine manufacturers is an important parameter, which corresponds to the temperature of chromium iron and cannot reach the solder material. If the temperature is too high, the material will burn out or cause damage to the building structure and reduce its strength. Because each company has selected different sensors, output sensors, and ultrasonic transducers with different amplitudes, and adjusted the cone and mold with different proportions, the scope of operation mold has been modified to meet the requirements. The output range of power devices is 10 to 20 microns, and the operating range is approximately 30 microns. Small size and mold displacement, such as small size and mold, indicating type, such as connection shape, front to back ratio range, type range, etc. Proportions before and after, and general statements. In the case of using branded welding machines in the company, the simplest method is to operate according to the size ratio of the mold to ensure the stability of the amplitude parameters.

In the working state of the vibration node, the amplitude of the two end faces is the largest and the constraint is the smallest. The amplitude of the node corresponding to the central orientation is zero, indicating the maximum stress. The joint orientation may not necessarily be zero amplitude. Joint orientation is usually fixed and planned. Fixed orientation planning is greater than 3mm, or some calls are caused by slot settings. Some calls are due to energy loss, usually blocked or covered with soundproof materials by rubber ultrasonic cleaning machine rubber rings and other components. Consider energy loss in the planning of amplitude parameters.

Article source: Jiangmen Ultrasonic Cleaning Machine http://www.kpzfcsb.com/