1. Place the cleaning machine near the water source and in a well drained area to ensure cleanliness and dryness under the machine base, and prevent moisture from corroding the transducer and heating elements;

2. Place the ultrasonic generator in a dry and ventilated area that is easy to operate and safe, to prevent dust, moisture, and cleaning solution water vapor from corroding the built-in electronic circuit board;

3. Connect the cleaning machine power supply and generator power supply as required, and it is necessary to reliably ground the machine body and generator separately;

4. Firstly, check if the power supply voltage meets the requirements, then dry the cylinder with a damp cloth and close the water valve;

5. Inject an appropriate amount of cleaning solution into the cleaning tank, and the liquid height should be increased to about 50 to 80mm from the cylinder surface;

6. Set the temperature controller to the required temperature according to the cleaning process requirements to meet the cleaning process requirements;

7. Participate in an appropriate amount of cleaning agent (according to the ratio of different cleaning solutions to the volume of the cleaning tank), wait until the desired temperature is reached (the heating indicator light subsides), turn on the ultrasonic generator switch, and start the cleaning operation;

8. When the cleaning solution becomes dirty after use and needs to be replaced, it is necessary to turn off the temperature control switch and heating power first, wait for 4 to 5 minutes, and wait for the heating device to cool sufficiently to a certain temperature before starting the liquid discharge and replacement operation. Otherwise, it is very easy to cause deformation of the cylinder body and burning and leakage of the electric heating device;

9. Regularly clean and wash the bottom of the cylinder, and keep the machine clean and free of liquid and dirt when not in use for a long time.

Article source: Jiangmen Ultrasonic Cleaning Machine http://www.kpzfcsb.com/